headerforhome

aboutusbuttonmaintainingbuttonpavementbuttoncolorbuttonconcretebuttonroofbuttonhowtobuttondealerbuttonpopbuttonstorebuttonaskbuttonencyclopediabuttone-mailbuttonproductbuttonmsdsbutton

  
Roof Coating & Repair Instructions
  
IMPORTANT - Read entire label before using. Application temperature must be a minimum of 60°F and rising. Do not apply when temperature is expected to drop below 50°F within a 24 hour period. In areas where dew or fog accumulates in the early evening, it is best to coat in the morning. Stop coating by early afternoon (3:00 pm) to prevent wash off, which will occur if dew, fog, or rain arrives before coating dries. Do not apply if rain is imminent or forecast within 24 hours of application. Be sure to wear eye protection when mixing or applying roof coating.

COVERAGE - One 5-gallon pail will coat approximately 250-500 square feet of roof surface.
  • Clean Roof - Sweep off all dirt, dust, and debris. Remove rust, mildew, oil, grease, or other foreign material on the surface. Allow freshly applied asphalt roofs to cure a minimum of 4 weeks prior to applying this coating. Scrub roof with solution of TSP (Trisodium Phosphate) and water. Remove mold and mildew with bleach solution (1 part chlorine bleach and 3 parts water). Rinse thoroughly and allow to dry.

• Roof Repair - Cracks, seams, skylights, vents, metal joints.

STEP 1 - With a 4” wide paint brush apply
a liberal amount of Elastomeric Roof Patch.

STEP 2 - Roll Reinforcing Fabric into wet roof patch. Smooth out fabric with paint brush.

STEP 3 - While material is still wet, brush another coat of Roof Patch over the Reinforcing Fabric. Be sure the fabric is completely embedded into Roof Patch material. Allow Roof Patch to dry completely before applying White Elastomeric Roof Coating.



• Applying Roof Coating - Stir pail thoroughly. Do not dilute. For best results apply White Elastomeric Roof Coating with a soft brush, 3/4” nap paint roller, or high pressure sprayer. For optimum performance and durability, apply a second coat.

CLEAN UP - Wash tools with water before material dries.