Concrete Instructions


		Concrete Sealing & Repair Instructions

		IMPORTANT - Read entire label before using. Application temperature must be a minimum of 50°F and rising. Do not apply when temperature is expected to drop below 50°F within a 24 hour period. Be sure to wear eye protection, gloves, long pants, and long sleeves when mixing and applying SealBest materials. In areas where dew or fog accumulates in the early evening, it is best to coat in the morning. Stop coating by early afternoon (3:00 pm) to prevent wash off, which will occur if dew, fog, or rain arrive before coating dries. Do not apply if rain is imminent or forecast within 24 hours of application. COVERAGE - For best results apply SealBest Concrete Sealer at a rate of 200 square feet per gallon (1,000 square feet per 5 gallon pail).

				• Clean Concrete Surface - Sweep all dirt and loose debris from concrete surface. Scrub all oil and gasoline stains with household detergent and water. Rinse off entire concrete surface with water and allow to dry thoroughly before applying concrete sealer.



				• Clean and Fill Cracks - Remove dirt and vegetation from cracks with screwdriver, wire brush or other suitable instrument. Clean out cracks with hose and water and allow to dry. Fill cracks up to 1/2” wide with SealBest Pourable Concrete Crack Sealant. Fill larger cracks up to 1” wide with SealBest Concrete Patch. Allow crack filler or patch to dry 24 hours prior to applying SealBest Concrete Sealer.



				• Applying Concrete Sealer - Stir pail thoroughly. SealBest Concrete Sealer is ready-to-use. Do not dilute. Apply a thin even coat of concrete sealer with a roller, brush, or garden type sprayer. For best results apply at a rate of 200 square feet per gallon per coat. Additional coats may be applied to create a higher gloss surface. Allow sealer to cure 24-48 hours before opening to vehicle traffic. CLEAN UP - Wash tools with water before material dries.